Power Door Lock Not Working On 2008 Dodge Ram

Average repair cost is 200 at 62 150 miles.

Power door lock not working on 2008 dodge ram.

The switch provides power to the door lock solenoids. Windows can still work but locks will all stop. I read in a forum that it could be the relay that has a 25a fuse in it that. Diagnose power door locks don t work properly.

All the switches on all four doors will not work either. Could be the issue or the relay it self is bad. I took the wire harness out and tested it and it works fine. Posted on sep 25 2008.

For a 10 relay gotta spend 500 1000 dollars to fix power door locks. It runs off a 5 volt reference. The 2008 dodge ram 1500 has 1 problems reported for power door lock stopped working. The reason the locks dont work more then likely there is a code stored in the bcm for a lock output circuit normally caused by one if not both of the sliding door acuators.

Symptom summary the power door locks are all inoperative or a single door lock is inoperative. Even if you change the acuators the locks still will not work until the code is cleared. Power door locks do not work. 21 people found this helpful.

The most recently reported issues are listed below. Check the driver side door switch control if that goes bad all the locks will stop working including for the key fob. My power windows on a 2008 dodge ram 1500 will not close. The rear window still opens though.

Dodge ram 1500 owners have reported 2 problems related to power door locks not working under the electrical system category.