Your latch is broken and you re locked out.
Replace latch on locked door.
If the door isn t locking replace the door lock motor with the manufacturer approved replacement part.
Reinstall the plastic cover and replace the assembly.
Check the alignment of the latch and strike plate.
Be sure to set all the pieces aside and to keep them together so that you won t lose them.
Pull out the two door knobs.
On models with mechanical latches.
Hi this video shows you how to replace a faulty door latch on an internal door.
Next you re going to want to find the source of the breakage.
Once you ve unscrewed the outer door handle remove it.
To take yours out just use your phillips screw driver again to take out the two screws in the face plate.
In some cases door latch plate mortises might need to be cut or enlarged.
First take a plastic card or cut a piece of plastic bottle and insert it between the door and the frame.
Do not force the latch at anytime.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
Once the oven is cool after a self clean cycle.
It should slide out fairly easily.
Do you need help replacing the door latch part w11307244 in your washer.
For service please schedule an appointment with ge appliances factory service.
Begin by removing the screws from the door knob on the interior side of your door.
If it s unaligned loosen the strike plate screws and shift it slightly.
If this works then you can open the door and it s time to replace the dead latch.
If the door will not unlock you may require service.
Again all door configurations are different so you may have a different set up.
Install the white plastic cover back onto the lock and actuator assembly by securing it with the two other screws you removed previously.
2 remove the two smaller.
The door lock motor assembly locks the latch to keep the oven door shut during the cleaning cycle and when the control lock out is active.
Now it s time to remove the latch.
Unscrew the two screws on the base plate of the door knob on the interior side of the door using a screwdriver with the appropriate head.
This allows you to pull the door.
You may want to spray wd40 or other lubricant on the lock mechanism.
Attach the plastic door lock actuator back onto the assembly with two screws.