Replacing Roof Trusses With Attic Trusses

One use of trusses is for the support of a roof they are similar to roof rafters.

Replacing roof trusses with attic trusses.

Often the height of the roof may be too low when constructed with truss rafters which means that it may need to be raised too. Once this is done you can either go with the new vaulted ceilings or use the empty space for an attic or loft. Attic trusses have a rectangular shape inside each truss. Replacing an entire roof truss this is obviously in the worst case scenario if the timbers are so badly damaged that there is no chance of repairing them and the only choice left is to remove all damaged trusses and replace with new ones.

Replacement of these furnaces can be difficult and sometimes cannot be done without cutting or modifying a truss. If the roof slope is steeper than 9 inches in 12 inches of run it doesn t take much width to end up with a nice room 12 feet wide with an 8 foot. First attic insulation hvac electrical wiring plumbing etc. The role of the horizontal beam is to tie the truss together and carry the load that would otherwise be sustained by the support and vertical timber also known as the king post.

The final step in the process is to cut out and remove the original trusses that were supporting the roof. This is accomplished by prepping the house to accept new floor joists and rafters. Furnaces are often located in attic areas. Next the roof shingles roof deck plywood or board sheathing and rafters are removed.

Some hvac contractors or installers may just cut a section of a truss out of the way in order to get. Attic conversions are now possible by replacing the truss rafters with a shaped trusses or horizontal beams which in return create additional space. If the plan is to use the space for an attic or extra room you must reinforce the ceiling so it will support the weight. A truss frame will occupy the majority of the space within the loft which means that the whole structure needs replacing if you decide to convert your attic.

The first step in reconstruction is to install new floor joists. This may well require planning permission.